Evaluation of genotoxic effects of benzene and its derivatives in workers of gas stations

The search for reliable biomarkers of human exposure to benzene and its derivatives is still subject of research. Many of the proposed biomarkers have limitations ranging from the low sensitivity to the wide variability of results. Thus, the aim of our study was to assess the frequencies of chromosomal abnormalities (CA) and sister chromatid exchanges (SCE) in workers of gas stations, with (cases, n?=?19) and without (local controls, n?=?6) risk of exposure to benzene and its derivatives, comparing them with the results from the general population (external controls, n?=?38). The blood dosages of benzene, toluene, and xylenes were measured in all participants. Blood solvent levels were compared with the findings obtained in cytogenetic evaluation and a research protocol which included data of the workplace, lifestyle, and health of the individuals. We did not detect the presence of benzene and its derivatives and did not find chromosomal damage that may be associated with the gas station activity in cases. Moreover, although we found an association of increased SCE and the working time in the local controls, the values found for SCE are within normal limits. Thus, our evaluation of SCE and CA reflected the levels of benzene and its derivatives observed in the blood. We believe, therefore, that SCE and CA may actually constitute possible tests for the evaluation of these exposures. However, we believe that further studies, including individuals at risk, are important to confirm this assertion.     

Alternating skimming flow over a stepped spillway

The study of stepped spillways in laboratory scales has been essentially focused on two separated sub-regimes within skimming flow. In this paper we investigate the appearance of an unclassified alternating skimming flow regime in a 0.5 m wide stepped spillway which does not fit on these earlier definitions, and which does not occur in a 0.3 m wide spillway. Our aim is to explain the genesis of this unclassified flow which is visualised in the physical stepped spillway, by using 3D numerical modelling. Flow depths and velocities are measured using an ultrasonic sensor and Bubble Image Velocimetry in the wider flume (0.5 m). The numerical model is validated with the experimental data from the 0.5 m wide spillway. After validation, the channel width of the same numerical model is reduced to 0.3 m wide spillway in order to characterise (compare) the case without (with) alternating skimming flow. Both cases are solved using Reynolds-Averaged Navier–Stokes equations together with the Volume-of-Fluid technique and SST k-\(\omega\) turbulence model. The experimental results reveal that the alternating skimming flow regime is characterised by an evident seesaw pattern of flow properties over consecutive steps. In turn, the numerical modelling clarified that this seesaw pattern is due to the presence of a complex system of cross waves along the spillway. These cross waves are also responsible for a mass and momentum exchange in the transversal direction and for the formation of the alternating skimming flow in the spillway.     

Occurrence of mycotoxins in wheat grains exposed to fungicides on fusarium head blight control in southern Brazil

Mycotoxins occurrence in wheat grains impose risks to human and animal health. The southern Brazil has favorable weather conditions for Fusarium graminearum infections and consequently for mycotoxins accumulation on grains. The goal of this study was to evaluate the behavior of new wheat commercial genotypes to Fusarium Head Blight (FHB), to control performance of new fungicide formulations and their relationship with mycotoxins concentration in grains. The manly mycotoxin occurrence on wheat grains in southern Brazil was deoxynivalenol (DON). Two cultivars showed high DON concentration above the tolerance limits (>3000 μg kg^?1). Many other mycotoxins monitored presented concentrations below method detection limit. Satisfactory levels of fungicide effectiveness were achieved against F. graminearum. Some fungicides promoted a satisfactory decrease on DON accumulation in grains. The best results were obtained when prothioconazole was present. SDHI (Succinate dehydrogenase inhibitors) + QoI (Quinone outside inhibitors) fungicides showed benefic effects at FHB control at field, but it did not promote satisfactory reduction on DON contamination. Fungicides can be used satisfactory for FHB control and reduce DON contamination in grains in southern Brazil. The presence of prothioconazole should be recommended. Some genotypes showed high DON concentration and it was not directly related with FHB severity at field.     

Comparison of USEPA digestion methods to heavy metals in soil samples

The use of appropriate analytical methods is of paramount importance for risk assessment and monitoring of potentially toxic metals in soils. In this sense, the objective of this study was to compare the effectiveness of two sample digestion methods, recommended by the Brazilian legislation for the management of contaminated areas (CONAMA 2009), aiming at the determination of environmentally available metal concentrations (USEPA 3050B, USEPA 3051A), as well as a total digestion method (USEPA 3052). Samples from 10 classes of soils were analyzed for Cu, Zn, Cd, Pb, Ni, and Hg. The results showed that the USEPA method 3051A is more efficient than the USEPA method 3050B in the extraction of levels considered environmentally available of Zn, Cu, Cd, Pb, and Ni. Besides providing a higher recovery of these elements, the method requires shorter digestion time, lower consumption of acids, and reduced risk of contamination. The USEPA method 3051A showed greater efficiency in Hg extraction in soils with higher clay content. Therefore, it is suitable for situations where a wide range of soils with different mineralogical characteristics are analyzed or in order to decrease the losses due to volatilization of the element in open systems.     

Assessing Degradation of Abandoned Farmlands for Conservation of the Monte Desert Biome in Argentina

Land abandonment is a major issue worldwide. In Argentina, the Monte Desert is the most arid rangeland, where the traditional conservation practices are based on successional management of areas excluded to disturbances or abandoned. Some areas subjected to this kind of management may be too degraded, and thus require active restoration. Therefore, the aim of this study was to assess whether passive succession-based management is a suitable approach by evaluating the status of land degradation in a protected area after 17–41 years of farming abandonment. Soil traits and plant growth forms were quantified and compared between sites according to time since abandonment and former land use (cultivation and grazing). Two variables were calculated using the CORINE-CEC method, i.e., potential (PSER) and actual (ASER) soil erosion risk. PSER indicates the erosion risk when no vegetation is present, while ASER includes the protective role of vegetation cover. Results showed that land use history had no significant effect on plant growth forms or soil traits (p > 0.05). After more than 25 years since abandonment of farming activities, soil conditions and vegetation cover had improved, thus having a lower ASER. Nevertheless, the present soil physical crusts may have delayed the full development of vegetation, enhancing erosion processes. Overall, this study indicates that succession-based management may not be the best practice in terms of conservation. Therefore, any effort for conservation in the Monte Desert should contemplate the current status of land degradation and potential vegetation recovery.     

Assessment of organic and inorganic contaminants in sediments of an urban tropical eutrophic reservoir

Although the Ibirité reservoir (an urban tropical eutrophic reservoir) has been the recipient of the discharge of a large volume of raw urban sewage, the key cause of ecosystem degradation has been historically solely attributed to the discharge of effluents from an oil refinery. This fact motivated an investigation to unravel the compositions of contaminants in the sediments to evaluate their distributions, possible sources, and potential impacts on sediment–water quality. The concentrations of polycyclic aromatic and aliphatic hydrocarbons and of metals and metalloids were, in general, significantly lower than some selected polluted sites used for comparison. Calculated distribution indexes showed that the hydrocarbon sources were petrogenic, pyrogenic, and biogenic. Only a few PAHs exceeded the threshold effects level (TEL) guideline. Industrial activities are the presumed sources of metals and metalloids except for copper, which is from copper sulfate used as algaecide in the reservoir. The bioavailable concentrations of some metal and metalloid exceeded the TEL–PEL guidelines. The acid volatile sulfide concentration was greater than that of the simultaneously extracted metals in the clayey–silty reservoir sediments, whereas the opposite result was observed for the sandy sediments of the tributaries. The sediment interstitial water toxic units were >1 for metals, thus indicating that metals are potentially toxic to the benthos. Considering the data set generated in this study, it can be concluded that the degradation of Ibirité reservoir and its tributaries cannot be solely attributed to the input of hydrocarbons, but predominantly to the discharge of raw urban sewage and effluents from other industrial sources.     

Green coconut shells applied as adsorbent for removal of toxic metal ions using fixed-bed column technology

This study applies green coconut shells as adsorbent for the removal of toxic metal ions from aqueous effluents using column adsorption. The results show that a flow rate of 2 mL/min and a bed height of 10 cm are most feasible. Furthermore, larger amounts of effluent can be treated for removal of single ions. The breakthrough curves for multiple elements gave the order of adsorption capacity: Cu⁺² > Pb⁺² > Cd⁺² > Zn⁺² > Ni⁺². Real samples arising from the electroplating industry can be efficiently handled.